

i’d still try hydrocarbon solvent first, because it’s least likely to damage it


i’d still try hydrocarbon solvent first, because it’s least likely to damage it


You can’t critihype it when you call it phage madlibs from the beginning


almost certainly both will damage print. something like lighter fluid (or hexane) won’t, but it should loosen glue. trying to dislodge sticker with a razor sometimes works even better
some people suggest vegetable oil, but then you’re left with oily fabric


waaaaay less impressive when you take a look inside
Once Evo got familiar with the genomes of Phi X-174 and its kin, the researchers prompted the model to write new versions of its own. Evo generated 700,000 potential versions; the scientists pursued only the ones that looked as if they had the best odds of succeeding.
They ended up making DNA molecules from 285 of Evo’s suggested sequences. […] All told, they discovered that 16 of Evo’s genomes produced viable new viruses.
Dr. Crook cautioned that Evo’s viruses were not radically new creations. They tend to be very similar to natural species, relying on the same underlying biology.
look out for breathless boosters “warning” everyone that ai will kill us all and it’s definitely not used as a marketing strategy


this also happens with dc once voltage is high enough


that bot setting is just irl evil bit


hornyposting on main must be one of these elusive family values then i guess


It’s easier to see that this circuit is rather symmetric when you redraw it

Then with both switches closed blue wire (the one in the middle) should only carry small current. If both halves are exactly the same it should be zero
In general when circuit doesn’t include nonlinear components (semiconductors most commonly) you can sum two valid solutions and you’ll get another valid solution. Note that when one switch is closed, current in blue wire goes one way and when the other is closed, in opposite way


“individual researchers with bold ideas” will mysteriously turn out to be republican techbros


if it’s that thick, i expect it’s some kind of pharmaceutical dissolved in oil. over time oil, like sesame oil, will gum up and darken like this


medical chatbot would be malpractice lawsuit pinata


Man brings man to the brink of death, for profit


botnet builders don’t care, and they’re doing this because they started at some point and nobody stopped them


they make great merchants too


some people say it’s august 8 then august 20


tapeworms and parasitic roundworms as a category
50mm^2 for 125A, just under 8mm diameter solid copper rod if it was solid copper rod. but it’s stranded so it’s a bit bulkier than that, bundled five per cable. it adds up to some 4cm in diameter
split phase is 2-phase system but everyone else uses 3-phase distribution. in reality americans also use 3-phase distribution, this is where 207v 3-phase comes from (it’s 120v phase to neutral)
the entire point of three phase circuit is that you can split it into single phase circuits without using too much wire. usually block will be wired so that 1/3 of flats is connected to one phase, but if you need to power big loads like ag tools or something like concrete mixer three phase supply can be done (415V these days, there’s upward shift in voltage)
set of hex keys and potion that gives you caffeine overdose. 10% chance of notebook with cursed knowledge